Installation Guide

Mounting the Inverter
Theinverterissuppliedwithoneofthefollowingtwotypesofmountingbrackets.
Themountingstepsinthenextsectionsrefertothesetypes.
Figure 14: Mounting bracket types
NOTE
Make sure the mounting surface or structure can support the weight of the inverter and
bracket, and make sure that it spans the width of the bracket.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting techniques, and
if required - a lifting aid when removing or replacing.
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez des
techniques de levage appropriées et, si nécessaire - un auxiliaire de levage lors du retrait
ou du remplacement.
1. Determinetheinvertermountinglocation,onawall,studframingorpole,asfollows:
l Toallowproperheatdissipation,maintainthefollowingminimumclearance
areasbetweentheinverterandotherobjects:

o
8"(20cm)tothetopoftheinverter

o
Atleast4"(10cm)tothebottomoftheinverter;ifconduitentrytothe
SafetySwitchwillbefromthebottomleavesufficientclearanceforthe
conduitsaswell.

o
4"(10cm)totherightandleftoftheinverter.Foreasyaccesstothefans
(singlephase10-11.4kWandthethreephaseinverters),youmayleave
largerclearance.

o
Wheninstallinginvertersoneaboveoftheother,leaveatleast16"(40
cm)betweeninverters.
SolarEdge-Installation Guide MAN-01-00002-4.0
28
Mounting the Inverter