Installation Guide

NOTE

When mounting an inverter with Type 2 bracket on an uneven surface, you may use

spacers/washers behind the top mounting hole of the bracket (see Figure 16). Depending

on the angle, use the appropriate size and number of spacers so that the bracket is

perpendicular to the ground. Recommended: a stainless steel 3/4" long screw, with a 1/4"

socket button head , two jam nuts and three washers.

Figure 16: Mounting on uneven surfaces

3. Hangtheinverteronthebracket(seeFigure 17andFigure 18):Lifttheinverterfromthe

sides,orholditatthetopandbottomoftheinvertertolifttheunitintoplace.Donotlift

holdingtheSafetySwitchasitmaybedamaged.

l ForType1-Usethescrewsatthetopoftheinverter,asshownbelow.Lettheinverter

layflatagainstthewallorpole.

Figure 17: Hanging the inverter on the bracket - Type 1

SolarEdge-Installation Guide MAN-01-00002-4.0

Mounting the Inverter