Installation Guide

l Error messages:Intheeventofaproblem,anerrormessagemaybedisplayedonthe
LCDpanel.Formoreinformation,refertoErrors and Troubleshootingonpage83and
Inverter Configuration – Setup Modeonpage51
Inverter Configuration – Setup Mode
Youcanconfiguretheinverterusingoneofthefollowing:
l TheinternalLCDuserbuttons.Whenusingthisoption,theinvertercoverisremoved.
l TheexternalLCDlightbutton.Whenusingthisoption,removingtheinvertercoveris
notrequired.Thisoptionofconfigurationincludesalessdetailedconfigurationmenu.
Configuring the Inverter Using the Internal LCD User
Buttons
Afterinverterinstallation,afieldtechnicianmayperformbasicsystemconfiguration.
ConfigurationisdonewhentheinverterisinSetupmode.
To enter Setup mode:
1. TurntheinverterON/OFFswitchtoOFF(ACremainsON).
WARNING!
If the inverter was operating properly (power was produced by the power
optimizers), the following message is displayed.
D C V O L T A G E N O T S A F E
D O N O T D I S C O N N E C T V D C : 7 2 . 0
This message is displayed until the DC voltage is safe (50V). Do not open the cover
until the voltage is safe or until at least five minutes have passed.
La tension de sécurité par défault est de 50V.
Ne pas ouvrir le couvercle ou les connecteurs DC jusqu'à ce que la tension soit
affichée comme sécurisé ou jusqu'à ce que cinq minutes au moins se soient
écoulées.
2. Removetheinvertercover:Opentheinvertercover’ssixAllenscrewsandcarefullypull
thecoverhorizontallybeforeloweringit..
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter
cover is removed.
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le
couvercle de l'onduleur est retiré.
Chapter 6: User Interface
SolarEdge-Installation Guide MAN-01-00002-4.0
51