Installation Guide

CAUTION!

The gland includes a rubber waterproof fitting, which should be used to ensure

proper sealing.

Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne

étancheïté.

3. Removetheplasticsealfromthelargeopeningthathasacutintherubberfitting.

4. RemovetherubberfittingfromtheglandandinserttheCAT5/6cablethroughthegland

andthroughtheglandopeningintheinverter.

5. Pushthecableintothecutopeningoftherubberfitting.

Figure 35: Cable glands and rubber fitting

CAT5/6standardcableshaveeightwires(fourtwistedpairs),asshowninthediagrambelow.

Wirecolorsmaydifferfromonecabletoanother.Youcanuseeitherwiringstandard,aslong

asbothsidesofthecablehavethesamepin-outandcolor-coding.

RJ45 Pin #

Wire Color

10Base-T Signal

100Base-TX Signal

T568B T568A

1 White/Orange White/Green Transmit+

2 Orange Green Transmit-

3 White/Green White/Orange Receive+

4 Blue Blue Reserved

5 White/Blue White/Blue Reserved

6 Green Orange Received-

7 White/Brown White/Brown Reserved

8 Brown Brown Reserved

The inverter connection does not support RX/TX polarity change. Supporting crossover Ethernet cables depends on the

switch capabilities.

Chapter 7: Setting Up Communication

SolarEdge-Installation Guide MAN-01-00002-4.0