Installation Guide

WARNING!
The supplied Safety Switch meets all requirements for a code-compliant installation of this
ungrounded system. The DC section disconnects both the positive and negative
conductors.
Le sectionneur externe (inclus) repond aux exigences de conformité pour l’installation de
ce système non-relié à la terre. Le coupeur CC ouvre les conducteurs positifs et négatifs.
WARNING!
The single phase 3-7.6 kW and three phase 9,10,20 kW must be connected to a dedicated
AC branch circuit with a maximum Overcurrent Protection Device (OCPD) of 40 A.
The single phase 10-11.4 kW and three phase 14.4, 33.3 kW inverters must be connected
only to a dedicated AC branch circuit with a maximum Overcurrent Protection Device
(OCPD) of 60A.
Les onduleurs monophasé 3-7.6kW et triphasés 9,10,20 kW doivent être connectés à un
branchement AC dédié avec un disjoncteur de 40A.
L’onduleur monophasé 10-11.4kW et triphasés 14.4, 33.3 kW doivent être connectés à un
branchement AC dédié avec un disjoncteur de 60A.
WARNING!
The inverter input and output circuits are isolated from the enclosure. This system does
not include an isolation transformer and should be installed with an ungrounded PV array
in accordance with the requirements of NEC Articles 690.35 and 690.43 National Electric
Code, ANSI/NFPA 70, 2011 (and Canadian Electrical Code, Part I, for installations in
Canada).
Equipment grounding is the responsibility of the installer and must be performed in
accordance with all applicable Local and National Codes.
Les circuits d’entrée et de sortie de l’onduleur sont isolés de l’enveloppe. Ce système
n’inclut pas d’isolation galvanique (transformateur) et devra être installé sans mise à la
terre du champ PV et en accord avec les articles 690.35 et 690.43 du National Electric
Code (NEC), ANSI/NFPA 70, 2011 (et du Code Electrique Canadien, Partie 1, pour les
installations faites au Canada).
La mise à la terre des équipements est la responsabilité de l’installateur et doit être faite en
accord avec les toutes les règles locales et nationales applicables.
CAUTION!
This unit must be operated under the specified operating specifications, as described in
the latest technical specification datasheet, available on the SolarEdge website at
http://www.solaredge.us/groups/us/products/overview .
SolarEdge-Installation Guide MAN-01-00002-4.0
8
IMPORTANT SAFETY INSTRUCTIONS