Installation Guide

ATTENTION:
ERECTION CREW
Introducing Versi-Tab
Tired of the constant builder-versus-erector debate about how
to seal tabs? End the tab-sealing debate once and for all with
Versi-Tab. Our new Versi-Tab stapling tab can be installed
using the traditional “fold and staple” technique or the newer
“lap tab” technique. Versi-Tab allows the installer to decide
how to seal the seams, eliminating the potential that the
material supplied to the jobsite doesn’t allow the erector to use
his preferred installation method.
Solarguard with Versi-Tab is manufactured with a 2” tab on
one side of the Solarguard material and a 4” tab* on the other
side. To install Solarguard with Versi-Tab using the “fold-and
staple” technique, simply fold the 4” tab over the 2” tab and
staple on 6” centers then fold again and staple again on 6”
centers between the previously-applied staples. To install
Solarguard with Versi-Tab using the “lap-tab” technique, simply
lay the two rolls of Solarguard directly next to one another and
let the 4” tab rest on top of the next roll of Solarguard (this
means the 2” tab faces the building interior and the 4” tab is on
the top side of the insulation, facing the roof). That’s it!
• Note: Tab widths are nominal. Actual tab width is approximately 1 ¾” and 3 ¾”