Quick installation guide

ManualsBrandsSolaria ManualsSolar PanelsPowerXT 355R-AC 355W AC Panel with Enphase IQ7+

Important: This guide is not intended to replace the Solaria PowerXT-R-AC Module installation instructions. This is a

brief overview of the module mounting installation process. Always refer to the Installation manual for all safety and

proper installation methodologies.

Quick Start – Solaria PowerXT-R-AC Module

Quick Start Guide

Solaria PowerXT-R-AC Module Mounting

Guidelines

Step 1. Plan and install the racking

Allowable rail locations with example of typical rail

conguration shown back of module view.

Step 2. Position the Enphase Q cable

A. Plan each cable segment to allow drop connectors

on the Enphase Q Cable to align with each AC

Module. Allow extra length for slack, cable turns,

and any obstructions.

B. Lay out the cabling on the racking for the AC branch

circuit. Make sure the cable is positioned in a way

that allows you to connect it to the microinverter.

Redening Home Solar

12”

4” CLAMPING

AREA

6” CLAMPING AREA

FRAME

Step 3: Connect the Enphase Q Cable into the junction box (Transition box to your homerun wiring)

Step 4: Terminate the Unused End of the Cable

Step 5: Ground the system

Summary of content (3 pages)

PAGE 1
Redefining Home Solar Quick Start Guide Solaria PowerXT-R-AC Module Mounting Guidelines Important: This guide is not intended to replace the Solaria PowerXT-R-AC Module installation instructions. This is a brief overview of the module mounting installation process. Always refer to the Installation manual for all safety and proper installation methodologies. Step 1. Plan and install the racking 12” Allowable rail locations with example of typical rail configuration shown back of module view. Step 2.
PAGE 2
Redefining Home Solar Step 6: Prepare the AC Modules Before installing the AC module, the microinverters must be lifted from the shipping position. On the ground, turn the AC Module so that the microinverter faces you. lift the microinverter up. You will hear four clicks as the microinverter locks into the installation position. Step 7: Use the Serial Number Labels to Create the Installation Map. The Enphase Installation Map is a diagram of the physical location of each module in your PV installation.
PAGE 3
Redefining Home Solar B. As each module is installed, connect the Q Cable to the microinverter. Listen for a click as the connectors engage. Step 9. Manage the Cabling Use cable clips to attach the cable to the module frame. Leave no more than 1.8 m (six feet) between cable clips. Step 10. Energize! If applicable, turn ON the AC disconnect or circuit breaker for the branch circuit. -T urn ON the main utility-grid AC circuit breaker. Your system will start producing power after a ﬁve-minute wait time.