Installation Guide

ManualsBrandsSOLAX POWER ManualsInverterSOLAX POWER X1 Series 5 kw On-Grid Inverter

Table Of Contents

I III

Quick Installation Guide

X1 Series 0.6KW-3.6KW

Packing Lists

Inverter Installation

PV Connection

Note:

1) Please refer to the appropriate instruction manual for the usage of optional accessories.

Pocket WiFi×1

(optional)

Expansion tube×2

Expansion screw ×2

Female DC unit×1

Male DC unit×1

Female DC unit×1

Inverter ×1

Warranty card×1

X1 Ser ies

User Manual

0.6kw - 3.6kw

The copyright of this manual belongs to Solax Power Network Technology(Zhe jiang) Co,. Ltd.

Any corporation or individual should not plagiarize, partitially or fully copy (including software,etc.),

Power Network Technology (Zhe jiang) Co.,Ltd. reserves the right of final interpretation.

Product manual×1

X1 Series 0.6KW-3.6KW

Quick installation guide×1

- Unscrew the bracket from the back of the inverter.

- Mark the position of the two holes.

- Screw the expansion screws.

- Match the inverter with the bracket.

- Screw the cross recessed screw on the right side.

- Drill holes with φ10.

- Depth: at least 50mm.

- Tighten the expansion tubes.

200mm

12 AWG

Cable size: 12 AWG

-Align the two halves connectors.

trip length:

7.0mm

Negative DC pin contact ×1

Positive DC pin contact ×1

Ring terminal ×1

AC terminal×1

300mm

positive DC

pin contact

male plug

nut

female plug

tight nut

negative DC

pin contact

clamp contact

cable

torque:1.2±0.1Nm torque:1.2±0.1Nm

Summary of content (2 pages)

PAGE 1
Inverter Installation II - Drill holes with φ10. - Depth: at least 50mm. - Unscrew the bracket from the back of the inverter. - Mark the position of the two holes. 200mm Quick Installation Guide X1 Series 0.6KW-3.6KW - Tighten the expansion tubes. - Screw the expansion screws. - Match the inverter with the bracket. - Screw the cross recessed screw on the right side. 300mm 300mm 300mm 300mm 300mm Packing Lists I PV Connection III Cable size: 12 AWG -Align the two halves connectors.
PAGE 2
Firmware Upgrading AC Connection IV 52.5mm outer jacket 6mm 2.Insert the tripped end of each three wires into holes in the female insert, then tighten each screw with L-type wrench. 55mm X1-0.6/0.7/1.1/1.5 X1-2.0 X1-2.5/3K/3.3K X1-3.6K Model - Open the communication lid on the bottom of the inverter as below. 1.Slide the cable nut and back shell onto the cable. trip length L,N cable(mm²) 2.5-6 2.5-6 Inverter+BMU 2.5-6 4-6 PE cable(mm²) 2.5-6 2.5-6 2.5-6 2.