Manual

CONNECTING
See Page 19 for illustration
1.
Untie the wire holding the Sleeve Spacer (24) in place on the ends of the
connecting arms (8 & 9). Align the hole in the rod ends with the hole in the
brackets of the left and right Handle Bar (10 & 11). The connector arm end
should be on the inside of the Handle Bar bracket. Secure both sides with
a Hex Head Bolt (134), Flat Washer (170) and Nylon Nut (159) by using the
Wrenches provided (184 & 187).
#170.5/16" x 20 x 1.5T
Flat Washer (2 pcs)
#159.5/16"x 7T
Nylon Nut (2 pcs)
#134.5/16"x 1-1/4"
Hex Head Bolt (2 pcs)
PLASTIC
See Page 19 for illustration
1. Match up the console covers (94 & 95) and secure with three Phillips head
screws (139) and two sheet metal screws (142).
2. Match up the outer Connecting Arm Covers (109 & 11 O)with the pre-
installed inner connecting arm covers (111 & 112). Install the outer covers
(109 & 11 O)onto the Left and Right Connecting Arms (8 & 9) and secure
each side with a Phillips Head Screw (139) and two Sheet Metal Screws (142).
Make sure you position the covers with the arrows pointing up. If they are
installed incorrectly, they will break.
3. Install Sliding Wheel Covers (104) on each side and secure with four Phillips
Head Screws (139).
4. Install the two Stabilizer Covers (117 and 118) on the middle stabilizer bar
with two Phillips Head Screws (139).
5. Install the Front Stabilizer Cover (103) on the front stabilizer with two Phillips
Head Screws (139).
6. Install the two incline Cover brackets (25), with the hole for mounting the
plastic cover on the bent tab facing rearward, and secure them on the Incline
Rail Assembly (2) with four Phillips Head Screws (145). Install the Rear incline
bar cover (115) on the rail base with two Screws (139).
7. Install the Rear Stabilizer Cover (116) on the Rear Stabilizer with four Phillips
Head Screws (139).
8. This step to be performed after the elliptical power is plugged in. Elevate the
incline to Level 8 and install the incline Rail front cover (113) up against the
middle stabilizer tube with four Phillips Head Screws (139).
•
#142.3.5 x 12mm Sheet
Metal Screw (10 pcs)
#139. M5 x 15mm
Phillips Head Screw
(29 pcs)
#145. M6 x lOmm
Phillips Head Screw
(4 pcs)
17 E25 / E35 ELLIPTICAL