Manual

CONNECTING
See Page 12 for illustration
1.
Untie the wire holding the Sleeve Spacer (23) in place on the rod-end
bearings, located on the ends of the connecting arms (8 & 9). Align the hole
in the rod ends with the hole in the brackets of the left and right Handle Bar
(10 & 11). The rod end should be on the inside of the Handle Bar bracket.
Secure both sides with a Hex Head Bolt (134), Flat Washer (170) and Nylon
Nut (159) by using Wrench (184) and Wrench (187).
#170.5/16" x 20 x 1.5T
Flat Washer (2 pcs)
#159.5/16"x 7T
Nylon Nut (2 pcs)
#134.5/16"x 1-1/4"
Hex Head Bolt (2 pcs)
PLASTIC
See Page 12 for illustration
1. Match up the console covers (E55:94 & 95, E95:196 & 197) and secure with
three Phillips head screws (139) and two Sheet Metal Screws (142) using the
short Phillips head screw driver (185). Tighten the Sheet metal screws 1st.
2. Match up the Connecting Arm Covers (111 &l12qnnercoversandlO9&
11O-outer covers). Install the inner covers onto the Left and Right Connecting
Arms (8 & 9) and secure each side with two Phillips Head Screws (139) and
two Sheet Metal Screws (142) by using the Short Phillips Head Screw Driver
(185). Install the outer covers onto the left and right handlebars (10 & 11)
and secure each side with two Phillips Head Screws (139) and two Self
Tapping Screws (142). Make sure the outer covers are positioned in
relation to the arrow on each sticker.
3. Install Sliding Wheel Covers (104) on each side and secure with four Phillips
Head Screws (139).
4. Install the two Stabilizer Covers (117 & 118) on the middle stabilizer bar with
two Phillips Head Screws (139).
5. Install the Front Stabilizer Cover (103) on the front stabilizer with two Phillips
Head Screws (139).
6. Install the two incline Cover brackets (24), with the hole for mounting the
plastic cover on the bent tab facing rearward, and secure them on the Incline
Rail Assembly (2) with four Phillips Head Screws (145). Install the Rear incline
bar cover (115) on the rail base with two Screws (139).
7. Install the Rear Stabilizer Cover (116) on the Rear Stabilizer with four Phillips
Head Screws (139).
8. This step to be performed after the elliptical power is plugged in. Run the
incline to position 8 and install the incline Rail front cover (113) up against
the middle stabilizertube with four Phillips Head Screws (139).
•
#142.3.5 x 12ram Sheet
Metal Screw (8 pcs)
#139. M5 x 15mm
Phillips Head Screw
(24 pcs)
#14S. M6 x lOmm
Phillips Head Screw
(4 pcs)
E55 / E95 ELLIPTICAL 10