Manual

CALiBRATiON PROCEDURE
1. Remove the safety key
2. Press and hold down the Start and Fast (speed up) buttons and replace the safety key.
Continue to hold the Start and Fast key until the window displays "Factory settings", then
press the enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs.
Kilometers). To do this, press the up or down key to show which you want, then press enter.
4. Make sure the wheel size diameter is 2.83 then press enter
5. Adjust the minimum speed (if needed) to 0.5 and then press enter
6. Adjust the maximum speed (if needed) to 12.0 and then press enter
7. Adjust the maximum elevation (if needed) to 15 and then press enter
8. Grade return- On (This allows the incline to return to zero when stop is pressed. For sale in
Europe, EU standards require this to be off)
9. Press start to begin calibration.The process is automatic; the speed will start up without
warning, so do not stand on the belt.
MAINTENANCE MENU
1. Press and hold the Start, Stop and Enter key at the same time, until the display shows
"Engineering mode" (it may say maintenance menu, depending on version).
Press the Enter key.
2. You can now scroll through the menu using the Fast/Slow keys. Use the Stop key to
return to previous menu selection.The menu selections are:
a. Calibration - Used to verify calibration
B. Factory Settings- Acces only allowed by manufacturing
C. Security - Allows you to lock the keypad so no unauthorized use of the machine is allowed. When the child
lock is enabled, the console will not allow the keypad to operate unless you press and hold the Start and
Enter buttons for 3 seconds to unlock the console.
D. Functions - Press Enter to access settings, use Speed Fast/Slow keys to scroll
I. Sleep Mode - Turn on to have the console power down automatically after 30 minutes of inactivity
II. Pause Mode- Turned on to allow S minutes of pause, turn off to have console pause in de_nitely)
III. Maintenance- Reset lube message and odometer readings
IV. Units- Choose from English or Metric display readings
V. Grade Return - Returns elevation to lowest setting when pause is pressed
E. Key Test - Will allow you to test all the keys to make sure they are functioning
F. Display Test -Tests all the display functions
29 F80 / F83 / F85 TREADMILL