Safety Instructions

SRVO

DIAGNOSIS

GUIDE

1. Wireless switch unresponsive.

 Make sure battery is installed correctly. If blue and red light are flashing at the

same time, that means battery was not installed properly. If only blue light is

showing, that means battery was installed correctly and ready to pair SRVO and

wireless switch again.

2. No resistance on cable

 Switch to mode 3 isokinetic mode. Pull cable all the way out, slowly release the

cable. Restart the machine after cable is retracted all the way.

3. Cable stuck during session

 Release resistance, pull cable out forcefully. Slowly release the cable. Let the

cable retract all the way, machine should operate properly. Avoid pulling the cable

at high speed with less than 10 lbs of resistance.

4. Cable does not retract when machine is powered on.

 Unplug the machine and pull the cable all the way out. Then restart machine.

 If cable still does not retract, make sure machine stays on, pull cable all the way

out until you hear a banging sound. Banging sounds means cable is pulled all the

way out. Slowly release the cable, then restart machine.

5. Display does not light up

 Reset power switch of the machine.

 If cooling fan is not running, that means there is no electricity running through

machine. Make sure the machine is plugged in and power switch is turned on.

 If the cooling fan is running but display does not light up. Engage resistance and

see if there is weight applied onto cable. If resistance works properly, that means

the display screen is defective. If resistance does not work properly, that means

the control board is defective. Contact seller for further assistance.