User's Manual

[2006/11/08 11:11:0] [tCfg] receive msg = 0x301b

[2006/11/08 11:11:0] [tCfg]Syn_Src[1] Antanna Mask in NvRam[00ff]

[2006/11/08 11:11:0] [tCfg]GPS not ready, config Antenna Mask with

0x0000

[2006/11/08 11:11:0] [tCfg]Antanna Mask:[0000]

[2006/11/08 11:11:0] [tCfg]Send L1GenData0[0001]:

[2006/11/08 11:11:0] [tCfg]Send L1GenData1[0000]:

[2006/11/08 11:11:0] [tCfg]Send L1GenData2[0000]:

[2006/11/08 11:11:0] [tCfg] receive msg = 0x3012

[2006/11/08 11:11:0] [tCfg] send Data Init Finish Notify to tSys

[2006/11/08 11:11:0] [tSys] receive Data Init Finish Notify from tC

[2006/11/08 11:11:0] =====================

[2006/11/08 11:11:0] BTS IS WORKING STATUS

[2006/11/08 11:11:0] =====================

BTS startup is now successful.

[2006/11/08 11:11:0] [tCfg]Boot from NvRam success!

[2006/11/08 11:12:0] [tGPS] send msg M_L3_L2_L1_GENERAL_SETTING_REQ

RF Mask[0x00ff]success!

[2006/11/08 11:12:0] [tGPS] GPS locked!

[2006/11/08 11:12:0] [tCpeM] receive msg[0x200b] from task[3]

[2006/11/08 11:12:0] [tCpeM] receive msg[0x3706] from task[57]

[2006/11/08 11:13:0] [tCpeM] receive msg[0x3706] from task[57]

When the status of the BTS that you just booted up is shown as “connected" or “In

operation warning” in net element information screen in EMS, the BTS boot-up

sequence has been successfully completed.

3.4.2 Base Station reboot

When base station needs to be rebooted due to incidents happening to BTS or other

causes:

First, if the base station is in normal working mode, i.e. there is data output from BTS

serial port (or level 3 of telnet), you can enter command “reboot” in L3 command line or

“rebootL2” for only rebooting L2.