User's Manual

It is recommended to position the BTS cabinet as shown in Figure 2-2 in accordance
with the following guidelines.
 The spacing between the rear side of the cabinet and the wall should be at least
600mm.
 In the front side of the cabinet, at least 600mm spacing should be reserved as a work
area.
Fig 2-2: Layout of the network facility and location of BTS cabinet
Place the cabinets based on the engineering design requirements and accurately mark
out the positions of the supports on the floor. Install the accessories for cabinet
installation, as shown in Figure 2-3. Drill vertical holes with the appropriate punch drill
and drill bit, and then install M12 expansion bolts.
Figure 2-3: Installation of cabinet accessories
Do not over tighten the expansion bolts so that the installation accessories can be easily
moved if necessary. Install the cabinet in the preset position, and then rotate the