User's Manual

may start the CPE installation using the subsequent illustrations contained in this user’s
manual.
In the event of any difficulty during installation, please feel free to contact your CPE
provider.
CPE installation
Make sure your CPE is off before the installation, and the installation steps are as
follows:
1． Rotate the antenna 180 degrees clockwise, and fix the antenna by adjusting the
antenna lock nut.
Caution: Don’t overexert the antenna itself while rotate it. Fix the antenna by adjusting
antenna lock nut.
2． Insert the RJ45-connector of the Ethernet cable into the computer’s Ethernet
interface, and insert the other RJ45-connector of the Ethernet cable into the CPE’s
Ethernet interface.
3． Insert the connector of the phone line into the telephone’s phone interface, and
insert the other connector of the phone line into the CPE’s phone interface.
4． Insert one end of the power adapter connection line into the power supply interface
on the side
of CPE, and plug the other end into the 220V AC power socket.
5． Press the CPE power button, and state is “On”. If the power indicator light is off,
there should be something wrong with CPE or power adapter, please check the
equipment connections carefully.
If this activity doesn’t work, Please contact your CPE provider for help.
6． Observe the CPE signal strength indicator light:
CPE is searching the network if the light is flickering;
CPE has access to the BS if the light stops flickering, please follow the step 7;
if the light has been flickering for a long time, please refer to Troubleshooting on page 9.
7． Power your computer and log in, then configure the setting of your computer as the
requirement of network service provider, now you may surf the Internet.
8． You can use the phone without any settings. Just make and answer a call like
normal phone.
The Internet and voice services are provided by service providers, please make sure
they provide these services to you.
9． If don’t use CPE for a long time, turn off the CPE by pressing the power button until
the director light turns off.
Now your CPE installation is finished. If any problem exits, please refer to the next
section on troubleshooting.