Installation Instructions

• Fan Motors Permanently Lubricated-All units
have two fan motors for quiet operation and maximum
operating efficiency.
Motors are permanently lubricated to reduce
maintenance and totally enclosed to keep dirt and
water out of the motor windings.
• Indoor Fan Speed Selections LOW /HIGH-Unit
may be operated in low fan speed or high fan speed.
Some speed may not be present based on unit
capacities.
• Rotary Compressor -Smoother operation for quiet,
dependable service and high efficiency.
• Indoor Coil Frost Control-Prevents indoor coil from
freezing. Frost can form on the indoor coil when the unit
is operated in cooling when the outdoor temperature is
low. The unit automatically shuts the compressor off
until the indoor coil temperature warms to the point
where frosting will no longer occur. Then restart the
compressor.
UNIT ACCESSORIES
This unit is designed for through-the-wall installation in
new or existing buildings. To complete the installation
of this PTAC, an insulated wall sleeve and an outdoor
grille (either the stamped aluminum grille, or the
architectural grille ) are required.
The chassis
OPTIONAL ACCESSORIES
Power switch Kit
Wall Sleeve Kit
Key Lock Kit
Drain Kit
Filter Kit
Hard Wire Kit
Wire Harness Kit
Architectural Grille Kit
Stamped Louver Kit
LCDI Power Cord
Wireless IR Antenna
Wireless IR Thermostat
Electric And Non Electric Sub Base Kit
IR REMOTE CONTROLLER
NOTE: Consult sales literature for the appropriate
voltage and amperage selections, if applicable.
-3-
WARNING
HIGH VOLTAGE
DIS CO NNE CT ALL P OW ER BE FOR E SERV IC ING O R
INSTALLING THIS UNIT. MULTIPLE POWER SOURCES MAY
BE PRESENT, FAILURE TO DO SO MAY CAUSE PROPERTY
DAMAGE, PERSONAL INJURY OR DEATH.
(not included in this package).
,cabinet front and wall mount thermostat wiring
are shipped in one carton.