Model SG-WAC-25HCE Electronic Heat & Cool Window A/C Operating Instructions
Thank you for choosing a Soleus Air powered by Gree Air Conditioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new air conditioner. For your own records, please attach a copy of your sales receipt to this manual.
ELECTRICAL REQUIREMENTS The electrical ratings for your air conditioner are listed on the model and serial number label located on the front left side of the unit (when facing the front). Specific electrical requirements are listed in the chart below. Follow the requirements below for the type of plug on the power supply cord. Power Supply Cord Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove the ground prong. Do not use an adapter Do not use an extension cord.
PARTS LIST TOOLS NEEDED Large Flathead Screwdriver Tape Measurer Adjustable Wrench or Pliers Pencil Level Socket Wrenches Phillips Head Screwdriver Non-Hardware Packing List • • • • • • • • • Window Air Conditioner AAA Batteries (2) Top Mounting Rail Foam Top Mounting Rail Seal Strip Accordion Panels (2) Side Retainer (2) Window Sash Seal Foam Seal for Bottom Rail Owner’s Manual 4
SPECIFICATIONS • Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode. • Power consumption is measured when the fan runs at the highest speed setting. • These specifications are for reference only. For actual data, please refer to the rating label on the back of the unit.
INSTALLATION & ASSEMBLY INSTRUCTIONS Window Preparation Please read all instructions prior to installing your air conditioner. Two people are recommended to install this product. If a new electrical outlet is required, have the outlet installed by a qualified electrician before installing the unit. Before installing the unit, check the dimensions of your window to make sure the air conditioner will fit. This unit is made to fit inside a standard double-hung window.
INSTALLATION & ASSEMBLY INSTRUCTIONS - WINDOW MOUNTING REMOVE CHASSIS 1. Pull down the front panel and remove the filter (FIG. 1 below) 2. Lift the front panel upwards to remove and place to the side. FIG. 2 FIG. 1 3. Locate the four faceplate screws and remove. These screws will need to be re-installed prior to mounting the air conditioner (FIG. 2 above) 4. After removing the screws, gently pull away the faceplate from the air conditioner cabinet (FIG. 3 & 4). FIG. 3 FIG. 4 5.
INSTALLATION & ASSEMBLY INSTRUCTIONS - WINDOW MOUNTING REMOVE CHASSIS 6. Remove the shipping screws from the top of the unit and both sides of the cabinet if installed (FIG 6 & 7). FIG. 6 FIG. 7 7. Hold the cabinet while pulling on the base handle to carefully remove the unit. Do not pull or lift near the top of the unit (FIG 8). FIG. 8 8. Remove the internal packing material prior to installation (FIG. 9) FIG.
ASSEMBLY & INSTALLATION (CONT.) Top Angle Rail and Side Bracket Installation 1. 2. 3. 4. Place the air conditioner on a hard flat surface. Locate the foam gasket and top angle rail Attach the foam gasket to the top angle rail Install top angle side to cabinet as shown in FIG 7 Foam Gasket and Top Angle Rail FIG. 7 FIG. 9 TOP VIEW Placing the Cabinet Inside the Window 1. Open the window and place the cabinet in the middle of the window sill. 2.
Install Support Brackets Extend the Accordion Panels 1. Hold each support bracket flush against the outside of the window sill. Tighten each bracket to the bottom of the cabinet as shown below. Mark the brackets at top lever of the window sill and then remove. 1. Carefully raise the window to expose the accordion panel and panel frame. Loosen the locking screws so Mark the accordion panels slide easily. 2. Extend each panel to completely fill the width of the window.
ASSEMBLY & INSTALLATION (CONT.) Installing the Chassis into the Cabinet 1. Team lift (two people) the air conditioner chassis and carefully slide it into the cabinet. Let the front of the air conditioner hang out approximately 6”. 2. CAUTION: DO NOT PUSH ON THE CONTROLS OR FINNED COILS. 3. Be sure the chassis is firmly seated in the back of the cabinet. 4. Insert all screws removed during window installation and reattach the front face plate, front panel, and the air filter.
ASSEMBLY & INSTALLATION - THRU-THE-WALL (CONT.) Carefully measure and cut an opening with the following dimensions depending on your model (FIG. 1 & 2). WIDTH “X” = inside model plus twice the thickness of the framing material used. HEIGHT “Y” = inside model height plus twice the thickness of framing material used. Model SG-WAC-25HCE Inside Frame Height 18 7/8” (47.9 cm) Inside Frame Width 26 3/4” (67.
ASSEMBLY & INSTALLATION - THRU-THE-WALL (CONT.) Refer to the SUPPORT BRACKET ASSEMBLY in the WINDOW MOUNTING section to assemble the support brackets. A wooden strip nailed to the outside wall should be used in conjunction with the angled sill support brackets. FIG. 3 Support Bracket Wooden Strip 5. Screw or nail the cabinet to the wooden frame using shims if the frame is oversized, to eliminate possible noise. Remember to maintain proper slope for water elimination. MASONRY CONSTRUCTION 1.
USING YOUR AIR CONDITIONER Electronic Control Panel & Remote Control This display always shows the room temperature except when setting the Set temperature or the Timer. Air Conditioner Controls When the light is on the unit is in temperature or timer set mode. Light Indicates the Timer is set.
USING YOUR AIR CONDITIONER (Cont.) • Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions. • Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air conditioner. • Heat Mode: Use the Heat mode at Low, Med, High or Auto Fan Speed for heating.
ASSEMBLY & INSTALLATION (CONT.) USING YOUR AIR CONDITIONER (Cont.) • Freezing Conditions: This is a cooling only air • conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions. • Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air conditioner. • The remote control has a signal range up to 20 feet. NOTE: Auto Fan Speed cannot be used in Fan Only mode.
CARE AND CLEANING Clean your air conditioner to keep it looking new and to minimize dust build up. Cabinet Cleaning To clean the air conditioner cabinet: • Air Filter Cleaning The air filter should be checked at least once every month to see if it needs cleaning. Trapped particles and dust can build up in the filter and may decrease airflow as well as cause the cooling coils to accumulate frost. To clean the air • filter: 1.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS The Air Conditioner will not start The air conditioner is unplugged • Make sure the air conditioner is plug is pushed completely into the outlet The fuse is blown/circuit breaker is tripped. • Check the house fuse/circuit breaker box and replace the fuse or reset the breaker. Power Failure • The unit will automatically re-start when power is restored. There is a protective time delay (approx.
TROUBLESHOOTING (CONT.) PROBLEM POSSIBLE CAUSES SOLUTIONS Water is dripping outside Hot and Humid weather. • This is normal Water is dripping inside the room The air conditioner is not correctly tilted outside. • For proper water drainage, make sure the air conditioner is slightly tilted downward from the front of the unit to the rear. Water collects in the base pan Moisture removed from the air is draining into the base pan.
WARRANTY One Year Limited Warranty Soleus International, Inc. warrants the accompanying Soleus Air Powered by Gree Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States.