Installation Instructions

8
SLIDE UNIT INTO SLEEVE INSTRUCTIONS
Follow below steps to properly install the unit into the sleeve.
NOTE: Sleeve assembly instruction is not included in this manual.
1. Attach(4) 4 1/2” x 3 1/2” x 1 1/2” Optional Support Blocks two on each side of the Through The Wall
unit shown as figures below:
2. Slide the unit completely into the sleeve, make sure the ground wire does not become tangled.
3. Seal & Frame the unit as described in next page.
An optional Plastic Grille is also included in the package, however, it is highly suggested to use Aluminum Grille for bet-
ter air circulation.
1. Match the Plastic Grille on the back of the unit.
2. Secure the Screw and Washer on each side of the unit shown as below:
Screw
Washer
Plastic Grille
Unit
Optional
Support Block
Optional
Support Block
Optional Plastic Grille Installation