Model WS1-15E-02 WS1-18E-02 WS1-24E-02 15,000 BTU 18,300 BTU 24,000 BTU Electronic Window Air Conditioner Operating Instructions AIR CONDITIONER 2MF3 File No. SA 12793 Air conditioner must be upright for 24 hours prior to operating. This ensures that the compressor will function as intended.
PURCHASE INFORMATION Thank you for choosing a Soleus Air Window Air Conditioner. This Owner’s Manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Soleus Air Window Air Conditioner. For your own records, please attach a copy of your sales receipt to this manual.
POWER CORD AND PLUG This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment plug on the line side.
PACKAGE CONTENTS Window Air Conditioner (1) Remote Control (1) AAA Battery (2) Top Mounting Rail (1) Foam Gasket (1) Curtain (2) Foam Seal for Bottom Rail (1) Hardware Bag (1) Owner’s Manual (1) Weather Insulation Board (2) Window Sash Seal (1) Window Support Bracket (2) Hardware (In plastic Bag) Sash Lock Quantity 1 Screw and Locknut 4 Flathead Bolt and Locknut 2 Sill Angle Bracket 2 Curtain Lock 2 Long Screws 13 Short Screws 10 TOOLS NEEDED Large Flathead Screwd
SPECIFICATIONS Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode. Power consumption is measured when the fan runs at the highest speed setting. These specifications are for reference only. For actual data, please refer to the rating label on the back of the unit. Model Power Supply (Ph/V/Hz) WS1-15E-02 1/115/60 Rated Cooling Capacity (BTU/h) 15,000 Cooling Power Input (Watts) 1,230 Rated Current Cooling (Amperage) 12 CEER 11.
ELECTRICAL SAFETY DISCLAIMER ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE PRESENATION OF THE MANUFACTURER. SOLEUS N.A. HAS NOT CONDUCTED AN INDEPENDENT TEST TO VERIFY THE INFORMATION AND SPECIFICATIONS PRESENTED HEREWITHIN.
INSTALLATION Window Preparation Please read all instructions prior to installing your air conditioner. Two people are recommended to install this product. If a new electrical outlet is required, have the outlet installed by a qualified electrician before installing the unit. Before installing the unit, check the dimensions of your window to make sure the air conditioner will fit. This unit is made to fit inside a standard double-hung window.
INSTALLATION INSTALLATION & ASSEMBLY INSTRUCTIONS - WINDOW MOUNTING REMOVE CHASSIS 1. 2. 3. Pull down the front panel and remove the filter (See Fig. 3). Lift the front panel upwards to remove and place to the side. Locate the four faceplate screws and remove. These screws will need to be re-installed prior to mounting the air conditioner (See Fig. 4). 4. After removing the screws, gently pull away the faceplate from the air conditioner cabinet.
INSTALLATION Top Mounting Rail Curtain Installation 1. Attach the top mounting rail to the unit with short screws (Fig.8). Fig. 8 2. Slide the free end of the curtain into the side panel of the air conditioner. Do this for each side. The flange for securing the curtain into the window sill will be facing the room side when installed (Fig.9). Weather Insulation Boards Fig. 11 Curtain Place the Cabinet Inside the Window 1. Set the cabinet in the window so that is centered.
INSTALLATION Install Support Brackets 1. 2. 3. 4. Hold each support bracket flush against the outside of the window sill. Tighten each bracket to the bottom of the cabinet as shown below. Mark the brackets at top lever of the window sill and then remove. Assemble the sill angle brackets to the support brackets at the marked position as shown above. Hand tighten, but not all the way for any changes that may need to be made later during installation.
INSTALLATION Installing the Chassis into the Cabinet 1. 2. 3. 4. Team lift (two people) the air conditioner chassis and carefully slide it into the cabinet. Let the front of the air conditioner hang out approximately 6”. CAUTION: DO NOT PUSH ON THE CONTROLS OR FINNED COILS. Be sure the chassis is firmly seated in the back of the cabinet. Insert all screws removed during window installation and reattach the front face plate, front panel, and the air filter.
CONTROL PANEL Electronic Control Panel & Remote Control Note: This control panel display always shows the room temperature in Fan Mode except when setting the temperature and timer. Normal Operating Sounds You may hear a pinging noise caused by water hitting the condenser on rainy days, or when the humidity is high. This design feature helps remove moisture and improve efficiency. You may hear the thermostat click when the compressor cycles on and off.
REMOTE CONTROL LCD Display MODE SLEEP FAN HIGH ENERGY SAVER FAN MED TIMER FAN LOW C/ F CHILD LOCK MYTEMP MODE Battery Size: AAA - NOTE: Do not mix old and new batteries or different types of AAA batteries. .
OPERATION INSTRUCTIONS 1. ON/OFF - Press the button to turn the A/C on or off. When the unit is turned off, the Timer function will be cancelled. The set temperature will be saved. 2. MODE SELECTION - Press the MODE button repeatedly to cycle between the different modes: Auto, Cool/Energy Saver, Dry (Dehumidifier), and Fan. 3. TEMPERATURE SETTING - Press the ▼ button to decrease the temperature when the unit is on. Stop pressing the button when the desired temperature is displayed.
USE THE AIR CONDITIONER Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions. Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air conditioner. The remote control has a signal range up to 20 feet. Make sure nothing is blocking the remote control signal from being received by the air conditioner.
USE AND CARE CARE AND CLEANING Clean your air conditioner to keep it looking new and to minimize dust build up. Air Filter Cleaning The air filter should be checked at least once every month to see if it needs cleaning. Trapped particles and dust can build up in the filter and may decrease airflow as well as cause the cooling coils to accumulate frost. To clean the air filter: 1. Remove the filter by pulling down on the indents of the filter door on the front of the unit (See FIG. 14). 2.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSES The Air Conditioner will not start The air conditioner is unplugged Make sure the air conditioner plug is pushed completely into the outlet. The fuse is blown/circuit breaker is tripped Check the main fuse/circuit breaker box and replace the fuse or reset the breaker. Power failure The unit will automatically restart when power is restored. There is a protective time delay (approx. 3 minutes) to prevent tripping of the compressor overload.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS Water is dripping outside Hot and humid weather This is normal Water is dripping inside the room The air conditioner is not correctly tilted towards the outside For proper water drainage, make sure the air conditioner is slightly tilted downward from the front of the unit to the rear.
LIMITED WARRANTY Two Year Components Limited Warranty Five Year Compressor Limited Warranty Soleus N.A. warrants the accompanying Soleus Air Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of TWO (2) years for components and FIVE (5) years for the compressor from the date of original retail purchase in the United States. If the unit exhibits a defect in normal use, Soleus N.A.
