Model 00 BTU Window Air Conditioner Οкпйркс
Thank you for choosing a Soleus Air Air Conditioner. This owner’s manual will valuable information necessary for the proper care and maintenance of your new a few moments to thoroughly read the instructions and familiarize yourself with aspects of your new air conditioner. For your own records, please attach a copy of your sales receipt to this manual.
LCDI POWER CORD AND PLUG This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment plug on the line side.
0 Top Mounting Rail Air Conditioner Owner's Manual Foam Seal Top Mounting Rail Weather Insulation Board Curtain Short Screw Insert Strip Long Screw Curtain Lock Sash Lock Part List: x x x x x Window Air Conditioner (1) Top Mounting Rail (1) Insert Strip (1) Short Screw (8) Curtain (2) x x x x x x Sash Lock (2) Foam Seal (1) Long Screw for Window Locking Bracket & Curtains (12) Curtain Lock (2) Owner’s Manual (1) Weather Insulation Board (2)
x Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode. x Power consumption is measured when the fan runs at the highest speed setting. x These specifications are for reference only. For actual data, please refer to the rating label on the back of the unit.
WARNING: Avoid fire hazard or electronic shock, DO NOT use an extension cord or an adapter plug. DO NOT remove any prong from the power cord.
00 9 0 ) $ Please read all instructions prior to installing your air conditioner. Two people are recommended to install this product. If a new electrical outlet is required, have the outlet installed by a qualified electrician before installing the unit. Before installing the unit, check the dimensions of your window to make sure the air conditioner will fit. This unit is made to fit inside a standard double-hung window.
0 00 NOTE: Top Rail and the side Panels are offset to provide the proper pitch to the rear of (5/16”). This is necessary proper condensation utilization and drainage. If you are not using the side panels, the rear pitch must still be main ! . Attach the top rail onto the top of the outer case using four # crews.
ASSEMBLY & INSTALLATION (CONT.) Curtain & Weather Insulation Board Installa- Placing the Unit Inside a Normal Window tion 1. Set the unit in the window so that is centered. Place NOTE: The Weather Ins$lation Board adds an extra layer of insulation to keep air from passing through the sides of the window air conditioner. Top Mounting Rail the unit so that from edge of the bottom rail is against the back edge of the sill. 2.
0 9 00 F 'H , .! & ) $ A storm window frame will not allow the air conditioner to tilt properly which in turn will keep it from draining properly. To adjust for this, attach a board or piece of wood to the sill. The board or wood piece should have a depth of at least 1 1/2”. Make sure the board or piece of wood is approximately 1/2” higher than the storm window frame. This will allow the air conditioner to tilt enough for proper drainage. (See FIG. ). FIG.
CONTROL PANEL OPERATING INSTRUCTINOS Cool Mode 1. Turn the MODE selector clockwise to select HIGH COOL, MED COOL or LOW COOL. 2. Turn the TEMPERATURE selector clockwise to select the higher cool settings or turn the selector counter-clockwise to select the lower cool settings. x Turn the MODE selector to OFF to turn off the unit. Fan Mode x Turn the MODE selector counter-clockwise to select HIGH FAN, MED FAN or LOW FAN. x Turn the MODE selector to OFF to turn off the unit.
USING YOUR AIR CONDITIONER Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air conditioner will automatically re-start in the setting last used prior to power loss. Timer will be cancelled when power is lost or interrupted. You may need to set a new time if desired.
1 0 * Clean your air conditioner to keep it looking new and to minimize dust build up. . To clean the air conditioner cabinet: x Unplug the air conditioner to prevent shock or a fire hazard. The cabinet and front panel of the air conditioner may be dusted with an oilfree cloth or washed with a cloth dampened in a solution of warm water and mild liquid soap. Rinse thoroughly with a damp cloth and wipe dry.
0 2 * 0 # $ 0 0 The air conditioner is unplugged x Make sure the air conditioner plug pushed completely into outlet The fuse is blown/circuit breaker is tripped. x Check the fuse/circuit breaker box and replace the fuse or reset the breaker. Power Failure x The unit will automatically restart when power is restored. There is a protective time delay (approx. 3 minutes) to prevent tripping of the compressor overload.
0 2 * F 'H 0 0 0 ) Hot and Humid weather. x This is normal ) The air conditioner is not correctly tilted outside. x For proper water drainage, make sure the air conditioner is slightly tilted downward from the front of the unit to the rear. Moisture removed from the air is draining into the base pan.
Warranty Soleus , - " warrants the accompanying Soleus Air Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for the period of parts specified below. 5 YEARS FOR COMPRESSOR YEAR FOR OTHER COMPONENTS This warranty shall not apply to broken or marred cabinets, accessories, knobs, filters or routine maintenance.