User guide

GPS Tour
GPS signals and its meaning:
You will hear a beep sound when the Watch has received a GPS signal or when the GPS
signal has been lost. LOST GPS signal will also be displayed in the screen.
Step 5) Pair your Heart Rate monitor:
The HRM belt is on standby and ready to send data to your Watch. Wear the belt directly on
your skin just below your breastplate. It should be snug enough to stay in place during your
run.
5.1. Push one tab on the strap through the slot in the HRM transmitter.
5.2. Wet both electrodes with a damp cloth on the back of the HRM belt. This will help create
a strong electrical connection between your chest and the HRM transmitter.
5.3. Wrap around the chest belt around your rib cage just below the pectoral muscles and
attach the other end of the strap to the HRM transmitter. The elastic strap should be
adjusted so that it is snug enough so that it will not move during use but not so tight as to
restrict breathing.
5.4. Link your HRM belt to the Watch.
Linking HRM belt while in SET mode/ HRM LINK:
• Press S7 to go to SET mode.
• Press S1 or S11 to HRM LINK (blinks) screen.
• Press S5 to enter HRM link. It will then start to search (within 1 min.) for HR belt
and once HRM linked is successful it will display the HR belt ID number.
!
Linking HRM belt while in HRM mode:
• Press and hold S11 until HRM LINK blinks.
• Press S5 to enter HRM link. It will then start to search (within 1 min.) for HR belt
and once HRM linked is successful it will display the HR belt ID number.