User's Manual

USERS MANUAL
Page 1 of 6
 System Requirement
Defining by customer
 Package Contents
Defining by customer
 Initial your product
1. Put two (AA) Alkaline batteries to keyboard battery room in bottom face and
please follow the pole mark inside the battery room.
2. Plug the receiver cable into your computer connector by their function color, the
purple is for keyboard.
3. Make sure your keyboard and receiver distance is under the effective range
which is indicating in specification section.
4. Turn on your computer to enjoy the no wired freedom.
Note. If you are first time install this keyboard, you can ignore “ID Setting” section
to use keyboard.
If can not be use in first time install on your computer, please follow the ID
Setting section to setting or please kindly to check the FAQ to find the
problem out and solve it.
 ID Setting
(You no need to do this setting when you use this keyboard first times)
When I need to do this setting?
 Change or replace the battery when battery power is low level.
 The character will be loss when I use keyboard.
 The symptoms of inference happen.
Setting procedures
1. Press the “CONNECT” button which in RECEIVER top face, the receiver
“ACTIVE” light will be flash and into the stand by mode to wait keyboard send
the ID code.
2. Press the “CONNECT” button which in keyboard bottom face, the receiver
“ACTIVE” light will be keep lighting 3 seconds to memory the newly ID code into
receiver, after “ACTIVE” light off that mean is the ID setting process is OK and
the keyboard can be use again.
NOTE:
 You may need a pencil tip or other small tip to press the CONNECT
button.