User's Manual

The procedures are
1.
Lift the MRDU onto the guide bracket and ensure the MRDU is level left to right
2.
Push the MRDU into the corresponding slot in the direction of the heat sink while levelling the
MRDU to guide bracket
3.
Make sure the MRDU is firmly inserted into the corresponding slot. Tighten the 4 corner screws
to secure the unit
4.
Install MRDU blank cards in all unused slots in the remote. First insert the blank card into the
corresponding slot, then tighten the captive screw to secure it
4.1.6 How to mount FANUnit
FAN unit is required to be installed on the bottom of the 5W remote as shown in the below figure.
In the case that MROU temperature on GUI exceeds 70℃ (1580F), the fan unit is required to be installed
on the bottom of the remote unit.
Figure 4.14 – How to mount FAN Unit
Confidential & Proprietary
33/39