Installation Manual

ManualsBrandsSolidRF ManualsAccessoriesCell Phone Booster for Home Up to 8, 000 sq ft Dual Interior Antennas Office Multiroom | Verizon, AT&T, T-Mobile, Sprint & More Signal Plus Cell Signal Booster Kit

1).outdoor antenna

1.Outdoor Antenna Installation:

Working Diagram (How It Works)

Connect the System

Package Contents

2).30 ft RG6 cable 3).booster

4). Power supply

5).15 ft RG6 cable

7).30 ft RG6 cable6). splitter 8).Indoor antenna 9).30 ft RG6 cable 10).Indoor antenna

Summary of content (4 pages)

PAGE 1
Working Diagram (How It Works) 1 10 2 8 7 4 3 9 6 5 Package Contents 5).15 ft RG6 cable 1).outdoor antenna 2).30 ft RG6 cable 3).booster 4). Power supply 6). splitter 7).30 ft RG6 cable 8).Indoor antenna 9).30 ft RG6 cable 10).Indoor antenna Connect the System 1.
PAGE 2
.Connect the outside antenna to the 30 feet RG6 cable, seal and fix the connector Secure the cable near the antenna to prevent cable damage caused by wind shaking 3.Connect the outside antenna to the “OUTSIDE” port of booster. 4.Connect the 15 ft RG6 cable to the booster at the “INSIDE” port. 6.Connect the other end of the coax cables to the panel antennas. 5.Connect the other end of the coax cable to splitter at the “INPUT” port, and two inside antennas' cables connect to the other side port. 7.
PAGE 3
Caution Seperation between Outside and Inside Antenna To Avoid Osillation Minimum Required Separation Distance Between every Indoor and Outdoor Antenna： 20 ft (6 meters) horizontal distance 13 ft (4 meters) vertical distance(As far as possible) Note that the indoor antenna and the outdoor antenna cannot face each other. Seal the Joints of the Outdoor Antenna and Cable 1.Make sure connectors are well screwed in 2.
PAGE 4
Caution Properly Handle Excess Cables If the coiled cable is too close to the antenna or booster, the system will be unstable. Make sure these coiled cables are more than 6 feet(2 meters) from the antenna or booster WARRANTY The Outdoor Unit and Indoor Unit are covered under a three-year product warranty for failures or defects that result from craftsmanship and/or materials. Dated proof of purchase should be retained for use in warranty cases.