Hardware Description

The Omni-directional antenna below has been approved for use with this module when installed into the host device (Host Device FCC ID:
2AQWE-GC170424). The antenna Gain with Cable loss is less than 6dBi.
FCC-approved Antennas
A WARNING: This device has been tested with Reverse Polarity SMA connectors as below. When integrated into OEM products, fixed antennas require
installation preventing end-users from replacing them with non-approved antennas. Other antennas excepted below one must be tested to comply
with FCC Section 15.203 (unique antenna connectors), Section 15.247 (emissions) and RF exposure when the module installed into the host
device indicated in this filling.
WARNING: The FCC requires that all spread spectrum devices operating within the Unlicensed radio frequency bands must limit themselves to a maximum
radiated power of 4 Watts EIRP. Failure to observe this limit is a violation of our warranty terms, and shall void the user's authority to operate the equipment.
This can be stated: RF power - cable loss + antenna gain <= 36 dBm eirp.
Fixed Base Station and Mobile Applications
RF Modules are pre-FCC approved for use in fixed base station and mobile applications. When the antenna is mounted at least 20cm (8") from nearby persons,
the application is considered a mobile application.
Portable Applications and SAR Testing
If the module will be used at distances closer than 20cm to all persons, the device may be required to undergo SAR testing. Co-location with other transmitting
antennas closer than 20cm should be avoided.
RF Exposure
This statement must be included as a CAUTION statement in OEM product manuals.
A WARNING: This equipment is approved only for mobile and base station transmitting devices.
Antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 *cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
Photo of the Omni-directional antenna used when device installed into the host device indicated above.