Operation Manual

5.As soon as the blades stop,remove the jug from the base. Remove the lid to check the contents or to

carefully push down solid or thick ingredients with a wooden or plastic spoon.

However, if you wish to add further ingredients,remove the measuring beaker from the mixing jug lid.Add

the ingredients to the jug and replace it. If required run the appliance for a few seconds more until the

contents have reached the required consistency.

6. Now remove the mixing jug from the base and take off the lid of the jug.

Liquid contents – from drinks, soups up to thickly flowing dough – can be poured out of the jug.

Clean the jug immediately after use according to the instructions on pages 41–43 (Cleaning and care).

Reset button

Motor overload protection button

The Solis blender is fitted with motor overtemperature

and overload protection. If an overload occurs, the

appliance switches off automatically.

If an overload occurs that trips the protection, unplug

the power cord and let the appliance cool down

for at least 10 minutes.Then press the overload

button (RESET button), which is located underneath

the blender base. (See Fig. 5) The blender is now

ready for operation again.

Cleaning and care

CAUTION: wear suitable cloves when working with

hot liquids.Take care not to burn yourself on the

mixing jug, or to scold yourself with liquids or steam

that splashes or runs over.

CAUTION: never use hard or sharp edged utensils,

caustic agents (disinfectants, scouring agents or pot

scourers) or scouring agents to clean the appliance

or the components. Do not use force when cleaning

the blade assembly in order not to bend the blades or

damage the bearing. Never clean the appliance or

parts in the dishwasher.

fig 5

BDA_Blender_Mixer_DE_FR_E.qxd 25.08.2004 16:25 Uhr Seite 41