Installation Guide

WWW.SOLISTONE.COM
GROUTING
We do not recommend grouting due to the butt-joint installation method for Basalt tiles.
SEALANTS
To prevent possible staining and discoloration, we recommend sealing all basalt tiles both BEFORE
and AFTER installation. You can change the look and color of the stones depending on the sealer
you select ranging from color enhancement, to different levels of gloss finishes, or just leaving
them natural. Whenever using sealants and acids, please ensure that you follow the
manufacturer’s recommended method of application.
BEFORE applying sealant, wash the tiles and let dry for 24-48 hours. This will ensure that moisture
is not present under the surface of the tile. Failure to allow tiles to dry completely before
application will result in permanent discolorations. We recommend testing all sealants on a single
tile before application. There are various products available on the market, however, we
recommend contacting your nearest tile supplier for the most appropriate sealer for your
application.
CARE & CLEANING
SOLISTONE Basalt tiles can be cleaned with a neutral mild detergent, or a PH neutral cleaner
specifically for natural stones. All natural stones are porous and have different levels of water
absorption and therefore staining may occur in different degrees if the stone is left unsealed.
Consequently, any spills should be cleaned quickly to lessen the degree of the stain. For tiles in
high traffic areas keep surfaces clean from abrasive dirt. Do not use abrasive cleaners, powders,
scouring pads, steel wool or sandpaper. Do not let soap, bleach or other cleaning solutions set on
the surface.