Instructions

3 x

3 min.

You will nd important information on your measurement value at www.aqua-check.de.

Please observe the safety notes for handling chemicals (see rear).

Silicon test

For fresh and salt water

Test preparation:

1 Fill both tubes up to the mark with the test water.

2 Add 3 drops of Si R1 to one of the two tubes

(test), close with the screw top lid and mix.

Leave standing for 3 minutes.

3 Add the contents of the Si R2 ampule to the test,

close with screw top lid and mix.

4 Add the contents of two Si R3 ampules to the test,

close with screw top lid and mix.

Measure after exactly 3 minutes

reaction time.

Measuring with AQUA-CHECK:

1 Reference measurement.

2 Test measurement.

2 x

AQUA-CHECKAQUA-CHECK

www.aqua-check.de

Immediate

PAGE 1
Si Silicon test For fresh and salt water Test preparation: 1 Fill both tubes up to the mark with the test water. 2 Add 3 drops of Si R1 to one of the two tubes (test), close with the screw top lid and mix. Leave standing for 3 minutes. R1 3x R2 3 min. 3 Add the contents of the Si R2 ampule to the test, close with screw top lid and mix. R3 2 x 4 Add the contents of two Si R3 ampules to the test, close with screw top lid and mix. -CHE CK 3 min. ww w.a qua -che ck.
PAGE 2
Si Silicon test Version 1.0 • 03/2012 Si R1 (silicon test) Corrosice R35: Causes severe burns. S1/2: Keep locked up and out of the reach of children. S26: In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S30: Never add water to this product. S45: In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible). Contains sulphuric acid Si R2 (silicon test) Irritant R36: Irritating to eyes.