Operation Manual

Parts subject to wear and tear, Guarantee
ENGLISH 44
E
N
G
10. Parts subject to wear and tear
Various parts are subject to application-specific or normal wear and must be replaced in good time,
when required. The following parts are subject to normal wear and are not covered by the
manufacturer's guarantee:
• Air filter
• Fuel filter
• All rubber parts which come into contact with fuel
• Clutch
• Spark plug
• Starter
• Cutting tools
• Operating materials
• Cutting tools: guide bar / saw chain
• Vibration damping elements made of rubber
11. Guarantee
The manufacturer guarantees trouble-free quality and will cover the cost of replacing parts which are
found to be faulty in material or workmanship within the prescribed guarantee period after the date of
purchase. Please note that specific guarantee conditions may vary from country to country. If in
doubt, ask your equipment vendor. He is responsible for guarantee matters.
We hope you will understand that we cannot be liable for damage resulting from the following causes:
• Non-compliance with the operating instructions.
• Neglecting essential maintenance and repair work.
• Damage caused by incorrect carburettor adjustment.
• Wear in normal use.
• Obvious overload by continuously exceeding the maximum performance limit of the product.
• Using non-authorised tools.
• Use of force, incorrect treatment, misuse and accidents.
• Damage from excessive heat due to dirt build-up around the cooling fan housing.
• Attempted adjustments and repairs by unqualified persons.
• Use of unsuitable spare parts or third party parts, if these are the cause of the defect.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire or rental industry.
Normal cleaning, adjustments or maintenance work fall outside the guarantee provisions.
A service centre authorised by the manufacturer must carry out all guarantee work.