Instructions / Assembly

l
l
l Place bollard base plate over anchor bolts and tighten nuts securing the base plate to
the foundation.
l
Fig 8
BOLLARD ANCHOR BOLT GUIDE
WIRING DIRGRAM
Fig 5
hex wrench
Fig 6 Ground
Fig 7
Ground
Fig 10
Supply Line
dimmer +
dimmer -
Supply Neutral
Supply Ground
0-10V Dim+
0-10V Dim-
LED BOLLARD
Black Wire
White Wire
Green Wire
Purple Wire
Gray Wire
Disassemble fixture by loosening set screws (x3) with hex wrench. (See Fig 5)
Lay fixture on its side, with anchor bolts in place. Keep wire connected.
Wires will stay in place during installation, and should not be disconnected. (See Fig 7)
Verify that wires are securely connected after installing the base.
Raise the fixture to its upward position,
and tighten the set screws (x3) with hex wrench. (See Fig 8)
Fig 9
3.40
0.40
0.40
0.40
3.40
3.40
3.93