Installation Instructions

ManualsBrandsSolutions Made Easy ManualsElectronicsSME LD-20D Leak Tracker Shut off valve

LD20-D LEAK TRACKER

Directions for Installation

(Please read carefully before starting the Installation)

Before attempting to install the LD20-D

Leak Tracker read through this installation

guide and decide if you are prepared to

complete the project with the knowledge and

equipment you have, or whether you need to

get help from a professional plumber. Also,

that your water supply is within the LD20-D

Leak Trackers specification range.

The installation must comply with Federal,

State and local building codes, please

contact your local Building Inspector prior

to starting the project.

FCC ID : SSULD20D100

FCC ID: SSULD20D200

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

PLEASE LEAVE THIS DOCUMENT WITH THE HOME OWNER

2 YEAR LIMITED WARRANTY

The SME LD20D Leak Tracker is warranted to be free from defects in material and

workmanship under normal use for 2 year from date of purchase. In the event of

a malfunction or failure of this product during this period, the purchaser should

properly package the entire unit and return it to the place of purchase with proof

of purchase, which includes date of purchase (for example, a receipt or sales slip)

SME Limited will replace the unit free of charge.

This warranty is limited to the original retail purchaser and is not transferable.

The warranty does not cover damage due to accidents, abuse, tampering, normal

wear and tear, freezing water or misuse, nor does it cover damage resulting

from service by unauthorized personnel. Any indication that the unit has been

tampered with will void the product warranty

LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR

REPLACEMENT OF A DEFECTIVE PRODUCT. SME SHALL NOT BE LIABLE FOR ANY

INCIDENTAL OR CONSEQUENTIAL DAMAGE, WHETHER DIRECT OR INDIRECT.

THIS WARRANTY IS EXPRESSLY GRANTED IN LIEU OF ALL OTHER WARRANTIES

EXCEPT IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES INCLUDING, BUT

NOT LIMITED TO: THE IMPLIED WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE

PERIOD OF THIS EXPRESS WARRANTY.

Some states do not allow the exclusion or limitation of incidental or consequential

damages, or limitations on how long an implied warranty lasts, so the above

limitations or exclusions may not apply to you. This Warranty gives you specific

rights and you may also have other rights, which vary, from state to state.

In the event you have any questions concerning the use and care of your SME

product or concerning service under this warranty or otherwise, please write to:

SME Limited, 2850 North Pulaski, Chicago, IL, 60641

NSF

SME

                  

Summary of content (6 pages)

PAGE 1
SME 2 YEAR LIMITED WARRANTY The SME LD20D Leak Tracker is warranted to be free from defects in material and workmanship under normal use for 2 year from date of purchase. In the event of a malfunction or failure of this product during this period, the purchaser should properly package the entire unit and return it to the place of purchase with proof of purchase, which includes date of purchase (for example, a receipt or sales slip) SME Limited will replace the unit free of charge.
PAGE 2
SECTION 1-Planning the Installation The SME LD20-D Leak Tracker system has two basic components, an intelligent Detector Valve and a Remote Controller. For maximum protection the Detector Valve must be installed in the cold water riser as close as practical to the point where the riser enters the property after the water meter and main shut off valve but before any branch line, in this way all water runs and point of use outlets within the property will be monitored.
PAGE 3
5. Away Mode Selector. This mode should be selected if the property is to be left unoccupied for longer than 24 hrs. In the event of any abnormal flow or leak the water supply is closed after a period of 10 minutes on flows below 10 l/hour or 2 minutes where the water flow is high, i.e. in the event of a significant leak or a burst pipe. 6. Reset. The Reset button is used to cancel an alarm signal or for cancelling any incorrect user input. 7. Manual Time Display.
PAGE 4
SECTION 4-Pre Installation Radio Frequency (RF) range and performance checks 1. Determine the correct location for the Detector Valve; attention must be made at this stage to the considerations outlined in the “Planning the Installation” section of this guide. Ensure that both the Optional AC input port and Valve close off button are accessible. 2.
PAGE 5
6. Turn on the water supply using the main shut-off valve. As the valve was cocked prior to installation the valve will be open allowing the system to be vented. 7. If no leaks are present carefully refit the valve upper assembly to the baseplate ensuring the correct engagement of the valve drive spigot into its socket; these are color marked yellow. Do not over tighten the securing screws. 8. Replace the batteries in the Detector Valve and replace the battery cover.
PAGE 6
SECTION 7-Security System Connections PROBLEMS The LD20D Leak Tracker may be connected into your home security system, a professional alarm engineer should carry out this work as it could invalidate you home insurance if you undertake this. The Leak Tracker can be installed across any free Zone on the alarm. The Leak Tracker does not require to be powered from the Alarm System as it acts as a closed/open switch.