User's Manual
Table Of Contents
- Overview
- The Front Panel
- The Back Panel
- The Internal Antenna
- Introduction
- Installing the SOMAport
- Unpack the SOMAport
- Choose the Best Location
- Power on the SOMAport
- Connect Computer Using Ethernet
- Connect Computer Using USB
- Connect Multiple Computers to the SOMAport
- Connect Telephones to the SOMAport
- Activate Service
- Finding Causes of Computer Problems
- Finding Causes of Telephone Problems
- The Signal is Weak
- There is a Fault Condition
- The SOMAport is Not Receiving Power
- There is a Problem with the Ethernet or USB Cabling
- There is a Problem with the USB Port Settings
- The Computer Uses an Old Dial-Up Connection
- Internet Explorer LAN Settings are Incorrect
- Ethernet Network Settings are Incorrect
- IP address Needs to be Renewed
- Troubleshooting
- Specifications
- Index
19
CONNECT COMPUTER USING ETHERNET
If your computer has an Ethernet port, use the supplied Ethernet cable
to connect your computer to the SOMAport.
If your computer does not have an Ethernet port, use the USB cable
instead. See “Connect Computer Using USB” on page 20 for more
information.
To connect a computer via Ethernet
1 Insert one end of the supplied Ethernet cable into the Ethernet port on the
back of the SOMAport.
2 Insert the other end of the cable into the Ethernet port on your computer.
sp3.book Page 19 Thursday, July 22, 2004 3:21 PM