User's Manual

GRA BER

Assigning the Single-Channel Remote as Primary

This process is followed when the end user desires to add a single-channel control point for a group of shades as well as

individual control. You must rst exclude all individuals and include the single-channel remote as the primary controller.

Exclude the 2-button as the Primary Controller

1. Triple tap the program button on the back of the

Virtual Cord.

2. The LED light bar on the Virtual Cord will blink, alternating

amber to identify exclusion mode.

3. Press and hold the button on the headrail endcap until the

light begins to blink green (about three seconds).

4. The LED light bar on the remote will turn solid green then

turn off and the shade will jog, conrming exclusion.

Include Single-Channel Remote as the Primary Controller

1. Double tap the program button on the back of the

Virtual Cord.

2. The LED light bar on the single-channel remote will blink,

alternating between amber and green lights to identify

exclusion mode.

3. Press and hold the button on the headrail endcap until the

light begins to blink green (about three seconds).

4. Shade will jog and LED will turn off.

5. The shade will now operate from the

single-channel remote.