User's Manual

GRA BER

GRA BER GRA BER

Joining an Existing Z-Wave Network

Removing a Device from a Hub

All shade end limits, controls, and intermediate positions should be programmed prior to joining the network.

1. Place hub into discovery mode (add device). There will be

some form of feedback from the hub that it is searching

for a device.

2. Place single-channel remote in programming mode by

pressing and holding the programming button until the

LED light bar begins to ash green then release

the button.

3. The hub will nd the device.

4. Follow instructions for the system.

1. Place hub into remove device mode (exclude).

2. Press and hold the programming button until the LED light

bar begins to blink green then release the button.

3. LED light bar will turn solid green and turn off.

4. Follow instructions on the hub.

Hold