User's Manual

ManualsBrandsSomfy Systems ManualsElectronicsSWF Basic Remote Control ZWave BRZ1

GRA BER

Adjusting Your Shade’s Default Upper Limit (optional)

Adjusting Your Shade’s Default Lower Limit (optional)

1. Briey press UP and release.

Allow the shade to reach its

default upper limit.

1. Briey press DOWN and

release. Allow the shade to

reach its default lower limit.

The lower limit of your shade is factory pre-set to a closed position matching the ordered legnth. You may want to

adjust the lower limit to accommodate window hardware or other obstructions. Note: a jog is a brief up and down

movement of the shade.

The upper limit of your shade is factory pre-set to an open position which protects the shade from damage while

maximizing view. If you desire the shade to have an upper limit at a lower position when fully opened, follow these

steps. Note: a jog is a brief up and down movement of the shade.

*PRODUCT SAFETY NOTE: When adjusting the upper limit on cellular or pleated shades, do

not raise the product too tight. Adjusting the product too tight can cause the motor to fail and/or

break/fray the internal cording. When installing a solar or roller shade in a fascia or cassette

valance, be sure the hembar does not lift into the fascia or cassette, as this could cause the

hembar to get stuck and/or damage the fabric.

*PRODUCT SAFETY NOTE: Be careful not to exceed the ordered product legnth, this may result

in damaged product. Should this happen, immediately push UP to correct. If your shade will not

lower to your desired lower limit, contact a customer service agent for assistance.

2. Once the shade stops, press

and hold UP and DOWN

buttons simultaneously until

the shade jogs. (A jog is a

brief up and down movement

of the shade.)

2. Once the shade stops, press

and hold UP and DOWN

buttons simultaneously until

LED light turns amber and

release both buttons. The

shade will jog and the remote

will ash green. The LED on

the shade will alternately ash

green and red.

3. Adjust your upper limit by

using UP or DOWN to move

your shade to your desired

upper limit.* The shade will

only move while UP or DOWN

is being pressed while in this

adjustment mode.

3. Adjust your lower limit by

using UP or DOWN to move

your shade to your desired

lower limit.* The shade will

only move while UP or DOWN

is being pressed while in this

adjustment mode.

4. When the shade is stopped at

your new desired upper limit,

press and hold UP and DOWN

buttons simultaneously until

the shade jogs.

4. When the shade is stopped at

your new desired lower limit,

press and hold UP and DOWN

buttons simultaneously until

the shade jogs.