Instructions

3. REPLACING THE DOOR STATION

3.1 Installing the door station

These operations must be performed with the power o.

Avoid installing the camera facing a light source, as images of visitors may be impaired.

We recommend that silicon sealant is applied between the rain shield and the wall/pillar (but not below the rain shield) and that

the door station is ﬁtted at a height of approximately 1.60 m.

[1]. Route all the cables into the rain shield.

[2]. Fix the rain shield to the wall/pillar.

[3]. Connect:

• the monitor cable to the ﬁrst 2 terminals on the door station:

M+ on the monitor to M+ on the door station

M- on the monitor to M- on the door station

• the electric latch/lock cable to terminals L+ and L- on the door station.

• the drive cable to the dry contact output (COM and NO) on the door station

Note: To feed the cables into the terminals, use a screwdriver to press on the square with the notch, feed the wires in, then

release.

[4]. Position the door station in the rain shield.

[5]. Screw the door station to the rain shield using the tamper-proof torx key provided.

3 54

M- M+ L- L+ NO COMNC

Monitor cable

Gate drive cable

Electric latch/lock cable