User manual

Storing the keypad in the central unit and storing the

badge in the keypad

See the main instructions for your alarm system to enter storage mode at the central unit.

1 You now have 2 minutes to press

on the keypad.

...BEEP! at the central unit conrms that the central unit has stored the keypad.

2 Pass the badge in front of the keypad reception area: BEEP!

To store a 2

badge, repeat the same operation.

Customising system operation

All the settings described in this section can be modied much more easily if you have an

LCD keypad or the computer interface. In this case, ignore this section.

All the codes to be stored must be between 0001 and 9998.

If your installation includes an LCD keypad then the installer and user codes on the control

keypad will automatically be identical to those present in your system. We recommend that

you note them down.

To customize a parameter, you must rst enter the installer menu by typing the code:

2 2 2 2 # (default code)

 BEEP! at the phone dialer  the code is correct

Next, you have 2 minutes to type the command to modify the parameter. The phone dialer indicates

whether this command has been accepted:

Command...

 BEEP! at the phone dialer

 the parameter has been

stored

 series of BEEPs!  the action is not conrmed

Example of the modication of the installer code:

2 2 2 2 # (default code)

 BEEP! at the

phone dialer

 the code is correct

You have 2 minutes to enter the new installer code XXXX by typing:

2 0 X X X X X X X X #

 BEEP! at the

phone dialer

 the code is correct

 series of BEEPs!

 the code is

incorrect