User's Manual

ManualsBrandsSOMMER Antriebs- und Funktechnik ManualsElectronicsReceiver module, e.g. for garage door operator

Table Of Contents

35en

Deleting all learned radio codes

 Press the learn button (1) and hold it until

– the LED (Radio) initially blinks for five seconds,

– and then slowly blinks for ten seconds,

– and subsequently blinks quickly for ten seconds.

When the LED (Radio) turns off, all radio codes are

deleted.

If the learn button is released prior to this, the radio

codes are not deleted.

Programming the drive

The drive controller automatically detects the required force

for opening and closing of the door automatically during the

following drive programming procedure. The force values that

are learned in are only high enough so that the drive opens

and closes the door without interruption. If an obstacle (e.g. a

person or a vehicle) blocks the door’s movement, the drive is

able to detect this since more force is required than the

stored value. In this case, the drive stops the door’s move-

ment for safety reasons. If this happens during the “Door

Close” movement, the door is subsequently opened com-

pletely.

For every run of the door, the controller compares the stored

force values (for opening and closing of the door) with the

actual value required and automatically adjusts the stored

values upon reaching the end position.

Radio

Power

Status

Safety

Command

Reset

LearnLearnLearn

Radio

Power

Status

Safety

Command

Reset

LearnLearnLearn

111

 Close the door by hand.

 Pull once on the emergency release cord grip (N) to stop

the carriage (1).

 Move the carriage back and forth slightly to ensure that it is

stopped in position.

 Plug the power plug into the power outlet or switch on the

circuit breaker or fuse that supplies the drive with electric-

ity.

The drive’s lighting blinks when the drive is fist connected

to the mains supply. This indicates that the drive is ready to

learn the code.

 Press the Reset button on the controller housing (1) until

the lighting LED “Status“ goes out. The LED “Status“ blinks

while being pressed.

 Release the Reset button. The lighting (2) and the LED

“Status“ blink.

Setting-up operation