User's Manual
Table Of Contents
39en
WARNING
There is the possible risk of injury or death if you do not
observe and comply with the following information.
Therefore, observe and comply with all listed instruc-
tions before operating.
Only operate the remote control when you have direct line of
sight to the door and no persons or objects are located in the
area of the door’s motion.
Drive through the door opening only after the door has
opened completely.
Store the remote control so that an unintended operation for
example, by children or animals is prevented.
Do not use the radio remote control in areas with sensitive
radio communications or systems (for example: airports, hos-
pitals).
Lighting
The integrated lighting switches on automatically when the
drive is operated. It can also be switched on using the radio
remote control or via the wall station (accessory) without the
drive being in operation.
Operating the drive with the remote
control
The remote control has a range up to 100 ft (30 m) depend-
ing on the surrounding area.
The remote has an integrated clip so that you can carry it as
you would a pen in your shirt pocket for example.
When closed, the remote control is protected by a stainless
steel case so as to prevent an unintended operation.
To access the buttons, slide the remote control body (1)
out of the stainless steel case (2). There are detent posi-
tions for each button (a total of 4 buttons).
To close the remote control body (1), slide it into the stain-
less steel case (2) up to the stop position.
Opening, closing, and stopping the door
In order to operate the drive using the remote control, this
drive function first has to “learn in” the code of a particular
remote control. See “Programming the hand-held transmit-
ter”.
To open and close the door, press the corresponding but-
ton on the remote control one time.
Depending on the starting position, the door either opens
or closes. The lighting is switched on and switches off
automatically after 180 seconds.
Press the corresponding remote control button during the
open/close procedure.
The door stops. The next press of the remote control but-
ton causes the door to move back to its respective starting
position.
Operation