User's Manual

44 en
Overview of special functions
You can set these functions using the DIP switches, see following section.
Settings
Function
DIP
switches
Function for “OFF” setting
(factorysetting)
Function for “ON” setting
Soft running for “soft”
opening and closing of the
door.
1
The drive always starts with the
soft running speed from the “Door
OPEN” and “Door CLOSE” end
positions. It accelerates to the
maximum speed and before
reaching the end position, it
reduces the speed again to the
soft running speed. A soft and
quiet opening and closing is thus
possible.
The drive moves with constant speed between
the end points/guide idlers.
Backjump for relieving the
door and drive mechanics
when closing the door.
2
When closing the door, the drive
moves to the defined end position
over the guide idler and stops It
subsequently moves slightly in
the “Door OPEN” direction to
relieve the drive mechanics of
stress.
The drive moves to the defined end position over
the guide idler and stops
Defined opening and clos-
ing.
3 Switched off.
To be able to use this function, two remote control
buttons for opening/closing have to have been
programmed. See chapter “Programming the
hand-held transmitter”.
Button assignment example:
Button 1: the door opens.
Button 2: the door closes.
The lighting can now no longer by switched on/off
via button 2 of the hand-held remote control.
Partial opening for partially
opening the door (for exam-
ple for air circulation in the
garage or with sectional
doors for example for an
entry for people or for
accessing a bicycle).
Caution: If the DIP switch 4
is set to “ON” then DIP
switch 3 is automatically
deactivated.
4
To partial opening, the drive
opens/closes the door completely.
To be able to use this function, two remote control
buttons for opening/closing have to have been
programmed. See chapter “Programming the
hand-held transmitter”.
Button assignment example:
Button 1 for normal operation: the door
opens/closes completely (independent of the
starting position).
Button 2 for partial opening operation: the door
opens partially (must be set. See “Setting position
for partial opening”). Subsequently open the door
completely with button 1 to again close it with but-
ton 1 or 2.
The lighting can now no longer by switched on/off
via button 2 of the hand-held remote control.