User's Manual
Table Of Contents
56 en
Troubleshooting
Close both lamp lenses (1), the lug must (2) snap into
place.
Plug the power plug into the power outlet.
Or
switch on the the electrical supply for a direct electrical
connection (switch on the circuit breaker or fuse).
Replacing hand-held transmitter battery
WARNING
There is the possible risk of injury or death if you do not
observe and comply with the following information.
Therefore, observe and comply with all listed instruc-
tions before handling the battery.
Do not store batteries where children can reach them. A child
could play with them and accidentally swallow a battery. Call
a doctor immediately if a battery is accidentally swallowed.
Never throw batteries into fire. They can explode.
Never dispose of batteries with the household waste Leaking
batteries can damage the environment. Please dispose of
batteries properly according to your local regulations.
Pack the batteries individually for storage or for disposal. Bat-
teries must never come into contact with metal objects, they
can ignite, discharge, or be damaged.
Only replace batteries with the batteries specified in this man-
ual.
H
“clic”
1
2
Slide the remote control body (1) out of the stainless steel
case (2) up to the stop position.
Pull the remote control (1) completely out of the stainless
steel case (2) by applying strong pressure at the location
indicated in the diagram (3) (lug).
Remove the battery (1) from the retainer (2) and install a
new battery (type CR 2032, 3 V) in the same position. The
side of the battery to the retainer base! (as shown in the
diagram)
Before putting back together, check whether the battery
was correctly inserted:
Press a button on the remote control. The LED must light
up. If the LED does not light up, the battery must be
installed in the opposite direction.
Warning
There is a possible risk of injury when assembling the
hand-held remote control. You can pinch your fingers
when assembling.
Proceed carefully when inserting the remote control
body into the stainless steel case.
2
1
CR 2032, 3V
1
2
3