User's Manual

24 en
Connection to a power outlet or directly
to the electrical supply
The drive is equipped with a 3-pole power plug and can be
electrically connected by plugging it into a 3-pole power out-
let. The electrical power outlet must be located within a maxi-
mum distance of 5’ (1,5 m) to the controller housing.
DANGER
There is the risk of injury or death through electrical volt-
age if you do not observe and comply with the following
information. Therefore, observe and comply with all
listed instructions before performing the electrical con-
nection.
If a grounded 3-pole power outlet has to be installed, this may
only be performed by a qualified electrician!
The drive can also be directly connected to the supply volt-
age. This electrical connection may only be performed by a
qualified electrician!
The valid local and national regulations must be observed for
the electrical connection.
Do not use an extension cable.
Do not use an adapter to bypass the grounding (3-pole to 2-
pole non-grounded plug). Never remove or alter the ground
pin on the plug.
Power outlet connection
 Plug the 3-pole power plug into a grounded 3-pole power
outlet.
Connection directly to the electrical
supply
DANGER
There is the risk of injury or death through electrical volt-
age if you do not observe and comply with the following
information. Therefore, observe and comply with all
listed instructions before the electrical connection.
The electrical connection directly to the electrical supply may
only be performed by a qualified electrician!
The valid local and national regulations must be observed for
the electrical connection.
During the installation, switch off the on-site circuit breaker or
disconnect the on-site fuse for the circuit that is to supply the
drive with voltage.
 Loosen the three cables (N = white, phase = black,
ground = green) on the terminal block (1).
 Unscrew the nut (2) and remove the high-strength cable
gland (3) together with the cable (4).
3
5
4
6
2
1
3
4
2
1
Electrical connections