Operating Instructions and Installation Instructions

Installation
t
– 15
26
5
1
3
2
4
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
6
Put the controller circuit board (1) into the base frame (2) and insert into
the direct connector (3). Put the cover (4) in place and fasten with
screws (5). Put the lamp cover (6) in place.
Installation variant C
1
3
2
4
23
Choose a suitable location for the controller housing (1) close to an
existing wall socket (2).
ATTENTION!
Bear in mind the installation position of the controller
housing (1). Ensure that the maximum length of the control
cable (3) of 6900 mm is not exceeded.
Install the control cable (3) (24 V) to the controller housing (1) in the
garage. Do not plug in the power mains plug (4) yet.
25
2
1
2
3
4
5
6
1
2
3
4
5
6
5
3
4
4x
24
250
ca 150
2
4x
95
1
6
ATTENTION!
Do not drill into the power supply line to the wall socket!
Do not plug in the power mains plug yet.
Drill four holes (Ø 6 x 40 mm deep). Insert anchor ttings (2) into the drill
holes. Delivery scope: 2x anchor ttings, 2x screws and 2x washers.
Afx the controller housing with four screws (1) and four washers (6),
align the unit properly and rmly tighten the screws.
Insert the end of the control cable (5) through the back of the controller
housing (4).
Connect the control cable (5): With hinged double doors, connect the
wire marked with 3 (green) to terminal 3 and the wire marked with 4 (red)
to terminal 4 of the direct connector (2). Shorten the control cable (5)
if necessary.
NOTE!
With hinged double doors, connect the wire marked with
3 (green) to terminal 4 and the wire marked with 4 (red) to
terminal 3 of the direct connector (2).
26
5
1
2
3
4
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
6
Put the controller circuit board (1) into the base frame (2) and insert into
the direct connector (3). Put the cover (4) in place and fasten with
screws (5). Put the lamp cover (6) in place.
25