Operating Instructions and Installation Instructions

Installation
t
– 16
Install the wall socket.
ATTENTION!
Wall sockets may only be installed by a trained electrician.
Protect the wall socket with a circuit breaker (16 A, slow-blow).
Comply with all applicable regulations (e.g. the German VDE).
A/B 27
H
1
3
2
4
C27
Install the socket (1) on the wall at a distance of approx. 0.5 m from the
controller housing (2) for variant A/B, or on the ceiling for variant C.
Install and hook up the connecting line from the socket (1) to the
electrical power mains.
ATTENTION!
Do not plug the power mains plug (3) into the socket yet.
Install and connect the additional
button
ATTENTION!
Only use the connection for potential-free closer contacts.
External voltage can damage or destroy the controller.
NOTE!
Installation of an additional button is only necessary if an
extra one is required apart from the integrated button.
NOTE!
Never lay the cable of the key switch along a power line as
this could cause interference in the control unit.
7
6
3
4
5
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
1,6m
A28
2
1
7
6
3
4
5
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
B28
1,6m
2
1
7
6
3
4
5
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
1,6m
2
1
C28
Install the key switch (1) in a suitable, easily accessible position in the
garage. Minimum height above the ground: 1.6 m.
Install the switch cable (2) in the garage. Connect the end of the cable
to the button (1).
ATTENTION!
Danger due to electric current!
Only touch the controller (4) on the outer edge.
Don't touch the electronic components.
Take off the lamp cover (3). Unscrew the screws (4) and take off the
cover (5). Upwardly pull the controller circuit board (1) out of the base
frame (6).
ATTENTION!
After installation, it is imperative that you check the drive to
ensure that it has been correctly adjusted and that it reverses
upon contacting a 50 mm high object on the oor.
ATTENTION!
After installation, it is imperative to check whether the drive
stops when it encounters a 20 kg load that attached to the
middle of the bottom edge of door.
ATTENTION!
After installation, ensure that no parts of the door protrude
into public sidewalks or streets.
3029
4
1
2
3
4
5
6
1
2
3
4
5
6
3
56
1
3
2
6
5
4
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
NOTE!
Connect any key switches (potential-free NO contact) that are
present in parallel to terminals 5 + 6.
Connect the switch cable (3) to terminals 5 + 6 on the direct
connector (4).
Put the controller circuit board (1) into the base frame (2) and insert into
the direct connector (3). Put the cover (4) in place and fasten with
screws (5). Put the lamp cover (6) in place.