Operating Instructions and Installation Instructions

Initial operation
t
– 18
1
2
1. Voltage uctuations e.g.: Actuate control device (e.g. button, hand-held
transmitter, etc.) once.
⇒ The door opens to the until the door OPEN end position is reached.
2. Check whether the door reaches the desired end positions.
⇒ Adjust the end positions if necessary. See the chapter
“Commissioning - adjusting the door Closed + Open end positions”.
Checking the emergency release
NOTE!
You can activate Backjump for sectional doors or doors
with ceiling guides by means of DIP switch 6; this relieves
the drive and door mechanisms. Simpler actuation of the
emergency release.
V
N
1
1. Close the door with the drive.
2. Pull once on the emergency release (N).
If the emergency release cannot be actuated, loosen the end switch (V)
and push it a bit in direction (1).
3. Open and close the door with the drive. Recheck the emergency release.
Check the force settings
For every run of the door, the controller compares the stored force values
with the actual values required and automatically adjusts the stored values
upon reaching the end position.
Check: See chapter “Care and maintenance / regular testing”.
Programming the hand-held
remote control
NOTE!
Before programming the hand-held transmitter for the rst
time, always clear the radio receiver memory completely.
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
5
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
R
adio
LED2
LED1
R
adio
LED2
LED1
3.2
1
3.1
Deleting the radio receiver memory
1. Take off the lamp cover.
2. Press and hold the Learn button (1).
⇒ After 5 seconds, the LED ashes (3.1 or 3.2).
⇒ After another 10 seconds, the LED lights up steadily (3.1 or 3.2).
⇒ After a total of 25 seconds, all LEDs light up steadily (3.1 and 3.2).
3. Release the Learn button (1) - the deletion procedure is ended.
Programming the hand-held remote control
1. Press the Learn button (1).
▫ 1x for channel 1; the LED (3.1) lights up.
▫ 2x for channel 2; the LED (3.2) lights up.
⇒ If no code is sent within 10 seconds, the radio receiver switches to
Normal mode.
2. Press the desire hand-held transmitter button (5) until the LED (3.1/3.2)
extinguishes, depending upon which channel has been selected.
⇒ LED extinguishes - programming is nished.
⇒ The hand-held transmitter has transferred the radio code to the
radio transmitter.
3. For the additional programming of hand-held transmitters, repeat the
steps above. A maximum of 112 memory locations are available for
each radio receiver.
Canceling the Learn mode:
Press the Learn button (1) until no more LEDs are lit.
Mount the information sign
N
N
46502V000-172006-0-OCE_Rev.A
1x1x
1x1x
46502V000-172006-0-OCE_Rev.A
A
B
The information sign concerning the function of the emergency release;
please hang on the emergency release cord.