Operating Instructions and Installation Instructions

– 20
t
Safety instructions
¾ Continuously monitor the door while it is in motion and keep all persons
away from it until the door is completely opened or closed.
¾ Never put your hand near the door when it is moving or near moving
parts.
¾ Only pass through the door only once it is completely open.
¾ There is a risk of persons being crushed or cut by the mechanism or
sharp edges of the door.
Open door
1
1
1. Press button (1) or hand-held transmitter button once to open the door.
2. Press the button (1) again for the door movement “OPEN”.
⇒ The door stays in place (depending on DIP switch 7).
3. If the door has stopped, press the button (1) again.
⇒ The door closes (depending on DIP switch 7).
Close door
1. Press button (1) or hand-held transmitter button to close the door.
2. Press the button (1) again for the door movement “CLOSE”.
⇒ The door stays in place (depending on DIP switch 7).
3. If the door has stopped, press the button (1) again.
⇒ The door opens (depending on DIP switch 7).
Pulse sequence of door movement
Set pulse sequence with DIP switch 7.
2
1
ON
DIP
3
4
5
6
8
7
1x
1x
1x
1x
STOP STOP
DIP 7 OFF, standard setting for all drives
(see diagram):
• Open - Stop - Close - Stop - Open …
DIP 7 ON:
• Button 1: Open - Stop - Open - Stop - …
• Button 2: Close - Stop - Close - Stop - …
Emergency release
ATTENTION!
The emergency release is only suitable for opening or closing
the door in case of an emergency, e.g. a power outage or
drive failure. E.g. a power outage or drive failure. It is not
suitable for regularly opening or closing the door for other
reasons. This could cause damage to the drive or door.
DANGER OF FALLING!
In case of an emergency release, the door could
independently open or close itself due to a broken spring or
incorrect setting of the weight balancing. The drive could be
damaged or destroyed.
NOTE!
It can be locked and released in any door position.
N
1. Pull once on the emergency unlocking cord (N).
⇒ The drive moves freely and the door can be moved manually.
2. Pull on the emergency unlocking cord (N) again.
⇒ The drive clicks into place and the door can only be moved
mechanically.
NOTE!
If there is a slip door installed in the door, but no slip door
safeguard, install slip door safeguard (see accessories
instructions).
If the garage door does not have a built-in slip door or the
garage does not have a separate entrance, you must install an
emergency release - a release lock or Bowden cable - that can
be operated from outside (see accessories instructions).
Control unit reset
2
1
Time
Reset
Radi
o
LED2
LE
D
1
Time
Reset
Radi
o
LED
2
LE
D1
2
Ti
me
Rese
t
Radio
LE
D
2
LE
D1
Time
Reset
Radi
o
LED2
LED1
Rese
t
R
eset
33
2
1
ON
DI
P
3
4
5
6
8
7
1. Take off the lamp cover (1).
2. Press button (3) until the light bulb (2) goes out.
⇒ Light bulb (2) off - force values deleted.
3. Release the button (3).
⇒ Light bulb (2) blinks and controller reset has been successfully
performed.
Operation / Use