Operating Instructions and Installation Instructions

– 26
t
General information
DANGER!
Never use a hose or high-pressure cleaner to spray down the
drive or the controller housing.
¾ Always disconnect the mains plug prior to working on the drive
mechanism.
¾ Do not use acids or alkalis for cleaning.
¾ Wipe drive clean with a dry cloth as required.
¾ Never put your hand near the door when it is moving or near moving
parts.
¾ There is a risk of persons being crushed or cut by the mechanism or
sharp edges of the door.
¾ Check the mounting screws and bolts of the drive for tightness and
tighten if necessary.
¾ Check the door according to the manufacturer's manual.
Cleaning chains and drive unit rail
7
8
1. Chain (7) or the drive unit rail (8) is very dirty - cleanse it with a clean
cloth.
2. If necessary, lubricate the chain (7) and drive unit rail (8) with a
“conductive” oil. Do not use any grease!
NOTE!
Specied types of oil: Ballistol, WD40 contact spray
Replacing light bulbs
1. Unplug the mains plug from the socket.
2
1
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
2. Take off the lamp cover (1).
3. Unscrew the light bulb (2) by turning it counterclockwise and removing it.
4. Insert new bulb (32 V, 18 W, BA 15s) and turn clockwise until it is locked.
5. Put the lamp cover (1) in place.
Replacing fuse
(warning light connection)
1. Unplug the mains plug from the socket.
1
2
4
3
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
2. Take off the lamp cover (1). Unscrew the screws (2) and take off the
cover (3).
3. Upwardly pull the controller circuit board (2) out of the base frame (4).
4. Replace defective fuse.
8
9
10 11
12
7
1
5. Fuse for warning light connection, terminals 11 + 12.
1 A fast-acting fuse.
5
1
3
2
4
Time
Reset
Radio
LED2
LED1
Time
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
Reset
Radio
LED2
LED1
6
6. Put the controller circuit board (1) into the base frame (2) and insert into
the direct connector (3).
7. Put the cover (4) in place and fasten with screws (5). Put on the lamp
cover (6) and lock in place.
Maintenance and care