Operating Instructions and Installation Instructions

General Information
t
– 6
Declaration of Installation
for the installation of an incomplete machine
in accordance with the Machinery Directive 2006/42/EC, Appendix II, Section 1 B
SOMMER Antriebs- und Funktechnik GmbH
Hans - Böckler - Straße 21 - 27
73230 Kirchheim unter Teck
Germany
hereby declares that the controller
duo / duo rapido,
as of the identication duo / duo rapido 01/10, complies with the Machinery Directive 2006/42/EC and is specied for
installation in a door system.
• The following fundamental safety requirements have been applied and observed in accordance with Appendix I:
- General principles No. 1
- 1.2 Safety and reliability of control units
Safety input I terminals 7 + 8: Cat 2 / PL C
Internal force limitation Cat 2 / PL C
Safety categories in accordance with EN 13849 - 1:2008
• Compliant with the regulations of the EC Building Products Guideline 89/106/EC.
For the operating forces part, the respective initial testing has been carried out in consultation with recognized
inspecting authorities. In doing so, the harmonized standards EN 13241-1, EN 12453 and EN 12445 have been
applied. For the tested combinations, refer to the “Reference list” table in the Internet under www.sommer.eu.
• Compliant with the Low Voltage Directive 2006/95/EC.
• Compliant with the Directive on Electromagnetic Compatibility 2004/1 08/EC.
• The technical documentation was drawn up in accordance with Appendix VII B.
The product may only be put into operation after it has been established that the door system complies with the
regulations of the Machinery Directive.
Kirchheim, 12/29/2009
Jochen Lude
Responsible for documents