Instruction Guide

Sonance Flex Bracket
Installation Instructions
Introduction
The Sonance Flex Bracket is installed during construction and serves as a guide for the drywall installer when cutting openings.
The Flex Bracket can be nailed, screwed or stapled to studs or joists in the desired location for the speaker. Once the drywall
is cut, the speaker is clamped to the wall or ceiling using its RotoLock
®
clamps (the Flex Bracket does not need to be removed).
This manual covers all Flex Brackets for Sonance Virtuoso
®
D- and DR-series and Sonance Symphony
®
T- and TR-series speakers.
Box Contents
Your Sonance Flex Bracket box should contain the following items:
• (10) Sonance Flex Bracket frames
• (20) Flex Bracket wings
• (40) Flex Bracket wing locks
NOTE: Wing locks for all rectangular and square Flex Brackets are RED ; wing locks for Sonance
Virtuoso DR Flex Brackets are
GREEN ; wing locks for Sonance Symphony TR Flex Brackets are YELLOW .
Installation
1. Hold the Flex Bracket frame with the “This Side Out” legends facing towards you.
2. Insert the wings into rectangular and square Flex Bracket frames at the corner entry points (see
Figure 1 ); insert the wings
into round Flex Bracket frames at the single entry point marked with the arrow (see
Figure 2 ).
• Once they are attached to the Flex Bracket frame, the Flex Bracket wings can be positioned anywhere around the frame
(see
Figure 3 ).
Figure 1: Inserting Wings into Rectangular and Square Frames
Figure 2: Inserting Wings into Round Frames
Figure 3: Sample Flex Bracket Wing Positions