Distributed Audio System Instruction Manual

46
DAB1 DISTRIBUTED AUDIO SYSTEM
DAB1 Inbound Serial Commands
Each DAB1 inbound serial command begins with a colon character (:), followed by a single letter that indicates the desired
command, then one or more parameters, and ends with a carriage return (<cr>).
CCoommmmaanndd SSyynnttaaxx PPaarraammeetteerrss SSttaattee CCoommmmeennttss
Zone Power :Zxy<cr> x = Zone 1 – 6; y = State 1 = On; 0 = Off Discrete Zone Setting
All Zones Off :Zy<cr> y = State 1 = On; 0 = Off Global Setting Only
Source Select :Sxy<cr> x = Zone 1 – 6; y = Source 1 – 4 Adjustable Discrete Zone Setting
Tuner Preset :Ryy<cr> yy = Preset 1 – 12 Memory Preset # Global Setting Only
Tuner Preset Step :R++<cr> ++ = Next Preset Adjustable Requires Firmware v2.0
:R--<cr> -- = Previous Preset Adjustable or higher
Tuner Band :Ny<cr> y = State 1 = FM; 0 = AM Global Setting Only
Volume :Vxyy<cr> x = Zone 1 – 6; yy = Vol 0 – 60 Adjustable Discrete Zone Setting
Volume Step :Vx++<cr> ++ = increase 1 step Adjustable Discrete Zone Setting
:Vx--<cr> -- = decrease 1 step Adjustable Discrete Zone Setting
Page Volume :Gxyy<cr> x = Zone 1 – 6; yy = Vol 0 – 60 Adjustable Discrete Zone Setting
Page Volume Step :Gx++<cr> ++ = increase 1 step Adjustable Discrete Zone Setting
:Gx--<cr> -- = decrease 1 step Adjustable Discrete Zone Setting
Mute :Mxy<cr> x = Zone 1 – 6; y = State 1 = Mute On; 0 = Mute Off Discrete Zone Setting
Balance :Bxyyy<cr> x = Zone 1 – 6; yyy = Bal -10 – +10 Adjustable; Center = 0 Discrete Zone Setting
Balance Bump Step :Bx++<cr> ++ = increase 1 step to right Adjustable Discrete Zone Setting
:Bx--<cr> -- = increase 1 step to left Adjustable Discrete Zone Setting
Bass :Lxyy<cr> x = Zone 1 – 6 yy = Bass -8 – +8 Adjustable; Flat = 0 Discrete Zone Setting
Bass Bump Step :Lx++<cr> ++ = increase 1 step Adjustable Discrete Zone Setting
:Lx--<cr> -- = decrease 1 step Adjustable Discrete Zone Setting
Treble :Hxyy<cr> x = Zone 1 – 6; yy = Treble -8 – +8 Adjustable; Flat = 0 Discrete Zone Setting
Treble Bump Step :Hx++<cr> ++ = increase 1 step Adjustable Discrete Zone Setting
:Hx--<cr> -- = decrease 1 step Adjustable Discrete Zone Setting
Simulate Button Press :Pzxyyy<cr>
SSeeee SS
IIMM UU LL AA TT EE
BB
UU TT TT OO NN
PP
RR EESS SS
CC
OOMM MM AA NN DD SS
oonn ppaaggee 4488
After each command is received the DAB1 will respond with ‘+OK’ if the command is recognized and executed, or ‘+ERR’
if the command is invalid. Note that even valid commands will return ‘+ERR’ if the DAB1 is not able to process them
(i.e. if it is turned OFF).